Hello there, what do you think? Can mixed media be clean and simple? If it can, the tag that I am about to share with you probably fits that category! I used a lot of different mediums on the tag but I still think the overall feel of the tag is a clean and simple style but I will let you be the judge of that!
PLEASE
NOTE: This post contains affiliate links. Please see below for my full
disclosure.
I started off by pressing the Spellbinders Butterfly Splatter BetterPress Plate onto a panel of white cardstock with Spellbinders Iris and Turquoise BetterPress Inks using the Spellbinders BetterPress Letterpress System. I then die cut it out using the torn edge panel in the Spellbinders Torn Edges with Tag Etched Dies set.
I added ink blending on top using Tim Holtz Peacock Feathers and Wilted Violet Distress Inks. I splattered on some water and lifted that up with paper towel to create some water droplets. I then splattered on Tim Holtz Peacock Feathers and Wilted Violet Distress Spritz, which gives a lovely shimmer to the tag but sadly canot be seen in the photos!
I then splattered on some Spellbinders Splatter White Opaque Watercolor mixed with a little water and set it aside to dry. Once dry, I felt like it needed a little stamping, so I grabbed the zig zagged lines from the Spellbinders Sculpted Scripted Floral Clear Stamp Set and stamped that twice onto the panel using Tim Holtz Wilted Violet Distress Ink.
I die cut the geo tag, from the Spellbinders Torn Edges with Tag Etched Dies set, as well as the arrow, from the Spellbinders Keepsake Capsule Page Etched Dies, on the panel, saving the little pieces so that I could use the eclipse technique. I cut the shapes again three times from white cardstock and then placed a piece of paper behind the panel and adhered the white ones in place first, followed by the ones cut from the panel.
I die cut the tag from the Spellbinders Keepsake Capsule Page Etched Dies and cut off the hole punched edge, as well as a little off the bottom to make it shorter. The butterfly panel was adhered on top using thin foam tape. I die cut the alphabet dies from the same set and adhered them to the tag to spell the word 'create'. To finish, I die cut the heart from the Spellbinders Happy Post Envelope Etched Dies from white cardstock and adhered it to the centre of the geo tag. I then added a black clip to the top to make it look a little like a clipboard.
SUPPLIES:
Here are the links to
what I have used on the project. Affiliate
links are used on some products. This means that if you make a purchase after
clicking on my link, I receive a small commission with no extra cost to you. I
truly appreciate your support when using these links. Please click on the logo below
the product to shop at your favourite store. All products were personally
purchased except marked with an asterisk (*) which were kindly sent to me to
use. You can read my full disclosure here.
This was definitely out of my comfort zone but I had a lot of fun making it! I have wanted to use that butterfly BP plate for some time, so I am glad I finally got around to using it. Thank you so much for stopping by today, I really do appreciate it. I hope you have a wonderful day!






No comments:
Post a Comment
Thank you for visiting my blog today! Please feel free to leave me a comment. I really appreciate receiving them. Please note that if you comment as unknown on a hop, you will not be entered into the prize draw unless you leave your email address in the comment. Please see my Privacy Policy for details on how your data is used when leaving me a comment. Thank you so much :)